SEAL Image 410 Guida alla Risoluzione dei Problemi Pagina 17
- Pagina / 36
- Indice
- RISOLUZIONE PROBLEMI
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
17
WEBBING FILMS WITHOUT A RELEASE LINER
The following are the basic webbing procedures for
webbing films without a release liner:
• Select films slightly wider than the image to allow for
a border without film waste. A border of 1/8” to
1/4” (3-6mm) is adequate.
• Ensure the main roller’s temperatures are set
according to the recommendations of the laminates
being used (see literature enclosed in your material
box).
WARNING! The rollers should be together and
turning while heating up to provide even heat
distribution and prevent roller flat spots from
developing.
• Once the laminator reaches correct operating
temperature, stop the laminator and raise the top
roller.
• Pivot the front table down for easier webbing access.
• Load and center the films on top and bottom unwind
shafts with the dull adhesive side facing out and the
unwind brake tension released.
NOTE: Check if the film widths of the lower
and upper web are the same!
• TOP FILM: Pull the film down from the top unwind
shaft, and place it evenly over the face of the top
roller.
• BOTTOM FILM: Pull the film up from the bottom
unwind shaft and place it evenly over the top film
draped over the face of the top roller.
• The two films will then heat and stick together.
• Set the Nip Setting to 1/16” (2mm) to allow for the
thickness of a leader-board.
• FILMS INTO NIP: Use the leader-board to push the
film(s) into the main roller nip.
• Lower the top roller and use the foot switch to
advance the leader board through the nip.
NOTE: Keep the film under tension (holding
back on the film roll) to prevent the photoelectric
eyes being tripped.
• When the film reaches the chill shoe, cut off the
leader board.
WARNING! Do not use open blades to cut or
slice on the surface of the chill shoe. Small cuts
and scratches will affect the output quality.
• Using the footswitch, feed the film into the pull
rollers.
• Check at the rear of the laminator, making sure the
film does not wrap around the enclosed pull rollers.
• Raise the top roller and set the Nip Setting to ‘0’, then
lower the roller again.
• Return the in-feed table to its working position.
• Apply light unwind brake tension gradually on both
unwind shafts until there are no wrinkles in the film
as it goes into the nip
• Run the laminator for about 3 feet (1 meter), to work
out any wrinkles. If wrinkles persist, cut the film and
web the laminator again.
YOU ARE NOW READY TO FEED IMAGES!
Film Path
Media Path
Figure 10. Webbing films w/o Release Liners
- 410 Laminator 1
- Owner’s 1
- Operation 1
- INTRODUCTION 3
- Maximum board length 4
- ENVIRONMENT CONDITIONS 5
- IMPORTANT SAFEGUARDS 8
- SAFETY FEATURES 9
- LAMINATOR FEATURES 10
- CONTROL PANEL 11
- PRESET PROGRAMS 13
- CHECKING OPERATION 14
- SET-UP AND OPERATION 15
- Stretch film tight 16
- Film Path 17
- Media Path 17
- Release Liner 18
- DECALING (HEAT-ACTIVATED) 19
- MOUNTING 21
- NK JET, ELECTROSTATIC, AND 22
- HOTOGRAPHIC 22
- ONTROL PANEL 22
- ENCAPSULATING 23
- PRE-COATING BOARDS 24
- APPLYING AN OVERLAMINATE 25
- PROCESS CONTROL SHEET 26
- PERIODIC MAINTENANCE SHEET 28
- ERROR CODES 29
- TROUBLESHOOTING GUIDE 30
- GLOSSARY OF TERMS 32
- SPARE PARTS LIST 33
- TECHNICAL SPECIFICATIONS 34
- LIMITED WARRANTY 35
Prodotti e manuali riguardandi Plastificatrici SEAL Image 410
Plastificatrici SEAL AquaSEAL SW-3300 Specifiche
(44 pagine)
(44 pagine)
Plastificatrici SEAL Image 410 Specifiche
(29 pagine)
(29 pagine)
Plastificatrici SEAL 44/62 Ultra Plus Specifiche
(40 pagine)
(40 pagine)
Plastificatrici SEAL AQUA AS-1600 Manuale Utente
(35 pagine)
(35 pagine)
Plastificatrici SEAL 65ProMD Manuale Utente
(60 pagine)
(60 pagine)
Plastificatrici SEAL AQUA AS-1600 Manuale Utente
(22 pagine)
(22 pagine)
Plastificatrici SEAL PRO 44 Manuale di Servizio
(42 pagine)
(42 pagine)
Whirlpool AWA 6122 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Waschmaschinen Whirlpool AWA 6122.
Wir stellen 2 PDF-Handbücher Whirlpool AWA 6122 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Commenti su questo manuale